It was a bear getting the wires out of the handlebars. Going back in was a bit easier by using some wire pulling lube and heat.
All the switches were disassembled and contacts cleaned before reassembly. Hope it all works. All the components and the main harness will be layed out on a large board so everything can be tested. The only variation from original is the electronic ignition vs the points and condenser, and an extra pair of resistors.
- Handlebars done.JPG (231.62 KiB) Viewed 35069 times
- Dash wires copy.JPG (255.33 KiB) Viewed 35069 times
Inside photo of the dash.
- Wiring dash2 copy.JPG (323.37 KiB) Viewed 35069 times