Carbs are in fairly good condition and after cleaning and vapor blasting they were disassembled. Jetting if a bit off for this motor and year so have to make a decision whether to test if first or go with manual's settings. Float needles show slight wear and probably ok as is but with a slight modification I can exchange them for a viton needle/seat combo that will work.
It's rather time consuming setting float levels when all 4 carbs are racked up on their frame so I mickie'd up a stand so I could do one at a time, at eye level. With my fuel level attachment I can fill, check, drain and adjust and refill much easier this way.
- Zir carbs.JPG (320.05 KiB) Viewed 9 times
- Carb float set.jpg (399.75 KiB) Viewed 9 times
- Carb float jig.JPG (210.62 KiB) Viewed 9 times