I got the seal for the kickstart shaft I had forgotten to order. So took off the side cover, fit the seal, installed the gasket and mounted cover. Bolted the footpeg bracket back up. Then thought I’d better see about the chain- I found a narrow ‘O’ ring chain I bought for something (not sure what) a...

Engine is in. On to work on wiring for the mods and Vape system

I cleaned up the frame, used a longer bar- and straightened them out no problem. Thanks for offer though.

I hqve not seen the new prototype. I will look

Any chance that could be a Fronterra with Pursang badges?
I don’t know enough about those to tell.

This bike has very unusual footpeg mounts. The later bikes went back to ‘standard’ but this has a bracket that goes under the exhaust, then up to the frame and rubber mounted to frame. The original owner fit a haywire sidestand for some reason (bike is very light and easy to put on centre stand)- an...

Ready to install

Pistons, cylinders, head on and fitting the Vape ignition/charging. The measurement tool I have for mm BTDC is a 12mm thread, so I have to make an adapter from 12 to 14mm so I can screw it in the sparking plug hole. I could use something else, but it does such a nice job. EDIT: I found I had a 14mm ...

Interesting, rim looks as wide as the rear, but maybe just the tyre is goofing me up.
Is that a 19”?

Looks very nice. Is that a rear wheel on the front?

I got another OSSA, an Explorer- he traded me for a Phantom frame I had. I don’t need it (by any means) and I think I will just get it operating and sell/trade.

Darn Spanish bikes anyway. Ha!

I was going to go to the Linden show, but got a sore throat the day before and didn’t feel like getting up at 4:30 to drive there. (Of course, next day I was fine). If the next ferry had space I think I would have gone. Oh well, I probably would have done something dumb and bought another bike too. ...